Step 1:  Connecting the hardware  Logging into an AcquiSuite requires an internet-enabled device with a web browser.  The device needs to be on the same

This article will walk you through programming your E-Gauge devices to push data to the Vitality platform. The E-Gauge device will push the values from

This article works with Obvius A8810, A8812, A7810, and Leviton A8810, A8812, A7810 This article will walk you through logging in to your Obvius devices.

This article works with Accuenergy AXM-WEB Push & AcuLink 810 Devices This article will walk you through programming your Accuenergy AXM-WEB or Aculink A810 to

The Accuenergy AXM-IO Module has the ability to connect 6 Pulse Outputs from Devices. Wire Connection Instructions 1. Connect the pulse output wire from the

Retrieving Logs with FTP Connection to Obvius Acquisuite Pre-Requisites FTP Client program such as Filezilla.   FTP Client must have set the FTP transfer mode to BINARY. (Very

Question What does the VOL on my Leviton 2000 display meter mean? Answer VOL means that the Phase to Neutral voltage is below normal.  When

For best results, the cellular modem and the DCAP need to be at least 6-8 feet away to minimize radio interference between the devices.  \

Question What’s the difference between a standard pulse output and a KYZ pulse? Answer Imagine a standard pulse as a light switch.  On/Off.  The light

The Obvius Acquisuite has the ability to connect to BACnet IP devices that are connected to the same network.  Currently, BACnet MSTP is not available

Prerequisites IP Addresses of each of the Devices Ethernet network between the devices and the Acquisuite needs to be connected. TCP Port 502 needs to

Step 1: Install Device Select a proper place for the location of the meter and the MDT.   Install the MDT device following appropriate local codes.

This article will walk you through connecting a pulse to a Tehama Submersible MDT Step 1: Install Device Select a proper place for the location

For best results, the cellular modem and the Gateway need to be at least 6-8 feet away to minimize radio interference between the devices.  ​ ​

Vitality needs the Meter Location added to the Transmitters in order to have a clean record for the data points coming from Tapwatch.  This is

YOU WILL NEED: Magnet (kitchen or industrial) Wire Cutters Wire Nuts DCAP Powered On CIT Software or Phone App STEP 1:  Verify Communication Like other

The Leviton Series 2000 Power meter has two different ways to pulse out to a gateway.   Summary Consider: Pulses are counted both on and off. 

Overview Connect the Wires Connect the Green (+) to the + or pulse side of the IO unit. Connect the Black (-) to the common,

AccuvimII Ethernet Module Using your internet browser, log into the Ethernet Module using the IP Address supplied by either the cell modem or IT network.

For best results, the cellular modem needs to be in an unobstructed area and be at least 6-8 feet away from any devices cellular or

Wiring Instructions To wire the F-5500, unscrew and remove the enclosure cap and loosen the two captive screws on the display assembly. Rotate it open

Overview Recommended Settings: Click on the Enter Button A password prompt should show: Password:  71360 Hit enter: Select  Pipe material: Flow: Gallons Flow units: Gallons

Retrieve EKM Display Key When you purchased your EKM Push, in your email from EKM they display the key.  Find that Key.   Here is an